Golf Cart Charger FAQ's

You need a charger that matches your cart’s battery voltage—commonly 36V, 48V, or 72V—and battery chemistry (Lead-Acid, AGM, or Lithium). FORM Charge has chargers for all major 36V and 48V carts for Lead-Acid and Lithium batteries. The 4-bank charger can also do AGM batteries.

Yes. FORM Charge smart chargers have SmartSense Maintenance Mode, which keeps the batteries safely topped off without overcharging.

A full charge typically takes 6 to 10 hours, depending on the battery capacity, how depleted the batteries are, and the charger's output amperage.

“Deep Charge” refers to the main charging stages that deliver the bulk of energy to the batteries. It ensures the batteries are thoroughly and efficiently charged before transitioning to maintenance mode.

Check for a working AC power source, inspect the outlet and any power strips, ensure the battery pack has enough voltage, inspect fuses or breakers, and check for corrosion or loose connections at the cart receptacle.

If the battery pack voltage is too low (below safe charging threshold of 18V), the charger may not activate. You can use a trickle charger to raise the voltage.

Yes—if each bank is connected directly to an individual battery and the charger banks are isolated. The FORM Charge 4-bank charger is designed for this kind of setup and will charge each battery independently, even if wired in series.

Check for corrosion on terminals, clean connections regularly, maintain proper water levels in flooded lead-acid batteries, and always recharge after use to avoid deep discharges.

Lead-acid batteries typically last 4–6 years with proper care. Lithium batteries can last 8–10 years, often longer, with significantly lower maintenance needs.

Common signs include reduced range, longer charging times, difficulty holding a charge, sluggish acceleration, and visible swelling or leaking..

Yes. Charging after each use helps prolong battery life and ensures your cart is ready to go the next time.

Charge regularly, avoid full discharges, keep battery terminals clean, use the correct charger for your battery chemistry, and store batteries in a cool, dry place when not in use.

Yes. FORM Charge chargers are designed for outdoor use and made with Advanced WeatherShield Coating. However, they should still be placed in a dry, well-ventilated area when possible.

If you want faster charging, more range, lower maintenance, and longer life, lithium is a great upgrade. It’s more expensive up front but can save money long term.

No. Mixing batteries of different ages or capacities causes uneven charging and discharging, which can damage both the old and new batteries.

The BMS protects lithium batteries by managing charge and discharge cycles, preventing overvoltage, undervoltage, overheating, and balancing the cells.

As long as the batteries are the same type and voltage, you can charge the entire bank as one unit. Make sure all connections are secure and balanced.

No. Each charger is designed for a single battery system. You should not split a single charger across multiple carts or battery packs.

Yes, but the generator must provide a clean and consistent AC output that matches the charger's requirements (usually 110V–120V AC). Make sure the generator is rated for the charger's power draw.

It’s normal for chargers to get warm as they work. Ensure there's airflow around the unit and avoid placing it on heat-retaining surfaces. Overheating could indicate poor ventilation or a fault.

The LED indicator lights show status: blinking during charge, steady green when complete. Refer to your manual for specific patterns that indicate charging stages or errors.

Need Additional Help or Want to File a Warranty Claim?

We have charger product specialists available to help